Table of Contents
Advertisement
If electrode fails to spark, check both electrode and igniter (see Section 3.12). If either component is faulty,
pilot may be lit with a flame.
With pilot established, continue to hold tap knob IN for a further 20 seconds, then release. The pilot should
now remain lit.
Should appliance fail to respond to these checks, then a replacement FFD magnet unit or thermocouple is
required.
SECTION 4 - SPARE PARTS
When ordering spares, always quote unit type and serial number.
This information will be found on the data plate.
The following parts may require replacing during unit life:
Spark ignition lead
Pilot burner assembly (Natural gas)
Pilot burner assembly (Propane gas)
Injector (Natural gas)
Injector (Propane gas)
Door seal
Door handle
Door pin (single action)
Drip tray
Control knob Shelf
Advertisement
Table of Contents
