Advertisement
provider.
3.2.1 Elements - To Replace
1. Turn off the mains water cock and drain the oven well.
2. Remove the element cover and connections to the faulty element.
3. Remove elements using a suitable spanner.
4. When fitting the replacement, place the rubber washer on the inside of the well and fibre washer on t h e
outside. Tighten the fixing nut firmly and replace the electrical connections.
5. Fill the tank with water and check for leaks before replacing the cover and switching it on.
3.3 CONTROL SWITCH and NEON INDICATORS Access to control gear components is gained upon removing the
control panel. Undo fixings at top of the panel.
3.3.1 Control Switch
To remove, pull off the control knob and release the fixing nuts.
3.3.2 Neon Indicator
To remove, remove terminals and undo the nut. Replace in reverse order.
T3.3.3 Ball valve
Turn off the water supply. Drain steamer at draw-off tap. Remove the lid from the cistern.
Remove the split pin from the valve body.
Raise the arm slightly and withdraw from the valve socket. Unscrew the cap at the valve end and pull out the valve
plug. Clean all parts with a soft rag (abrasives must not be used).
Replace in reverse order. Test soundness.
Flush out pipes to the reservoir. Allow the reservoir to refill.
3.4 DOUBLE CHECK VALVE
This component is maintenance free.
This water supply safety feature must always be fitted to prevent backflow. Ensure the flow direction arrow points
toward the ball valve inlet.
SECTION 4 - SPARE PARTS
When ordering spares, always quote unit type and serial number.
This information will be found on the data plate.
Advertisement
