Attaching Cabinet Front Panels; Section 3.3 "Attaching Cabinet Front Panels - Sun Microsystems Fire E6900 Installation Manual

3.3

Attaching Cabinet Front Panels

1. Place the first cabinet front panel as close as possible to the top of the system, and
secure the panel to the Sun Fire cabinet by tightening the screws through the left
and right sides of the panel.
2. Secure subsequent panels by tightening the screws through the left and right
front of each panel (
Place each front panel as close to the one below as possible. Use different sized front
panels as necessary to completely fill in the gap above the system. If unable to fill in
the entire gap leave the smallest possible gap at the top of the cabinet.
Note – The large cabinet front panels are not simply cosmetic, they prevent hot air
expelled from the rear of the cabinet from reentering the system from the front.
3. Secure small cosmetic panels on the cabinet adjacent to the system.
3-8 Sun Fire E6900/E4900 Systems Installation Guide • February 2004
).
FIGURE 3-4