Advertisement
TrekStep™ – Installation Instructions
2014 – Current Models Only
Reinstall the Small Support Bracket
Reinstall the bracket that was removed in Step 1.
Install Step
Use the M6-1.0 x 20 Socket Head Cap Screws to
mount the Step to the Linkage Assembly.
M6-1.0 x 20 Socket
Head Cap Screws
Rev. B 0223
Reinstall
Bracket
Step Adjustment
Once the Step is installed on the vehicle, you may
adjust it as desired.
If necessary to adjust the height, use the three
(3) 1/4" Spacers provided. Remove the M10-15 x
65mm Hex Bolts installed in earlier and place the
1/4" Spacers between the Frame Mount and the
Linkage. Reinstall the Hex Bolts.
When the Step is in the desired position tighten all
nuts.
2014 – Current Models Only
Reinstall the Bumper Caps
Line up plastic clips on bumper caps. Press down fi rmly to lock into place.
Adjust Step if Necessary
75505 pg. 5
1/4" Spacer
Linkage
Advertisement
