Advertisement
TrekStep™ – Installation Instructions
Remove Bumper Fasteners
Remove the bumper fasteners. Set them aside to be reused.
Install Linkage to Mounting Bracket
Use two (2) M10 x 45 mm Partial Thread Hex Head screws to secure the
Linkage to the Mounting Bracket.
2014 – Current Models: Secure the slotted end of the Side Bracket to the
outside bolt.
2013 and Earlier Models: Do not use the Side Bracket
Mounting
Bracket
Linkage
Rev. B 0223
Install Mounting Bracket
Align the holes in the Mounting Bracket with the holes on the vehicle.
Reinstall the fasteners removed in Step 8.
2014 – Current Models Only
Secure Side Bracket to Bumper
Use an M8-1.25 U-Nut and one (1) OE bolt removed in Step 2 to secure the
Side Bracket to the bumper.
Mounting
Bracket
Linkage
Side Bracket
M8-1.25
Bolt
U-Nut
Bumper
75505 pg. 4
Advertisement
