Summary of Contents for Bestop TrekStep Side-Mount
Page 1
Note: Passenger side installation shown. Driver’s side uses the same steps to install. www.bestop.com - We’re here to help! Visit our web site and click on “Ask a Question”. Click here for more Truck Accessories by Bestop. INSTALLATION TIME SKILL LEVEL 1/2 Hour 1 - Easy...
Page 2
TrekStep Side-Mount™ – Installation Instructions Parts List and Hardware Identifi cation Left End Cap, Running Board Assembly, Part Number Part Number 476.24, Qty - 1 M10-1.5 Nylock 460.83, Qty - 1 T-Nut Insert, Part Nut, Part Number Number 460.84, 484.92, Qty - 5...
Page 3
TrekStep Side-Mount™ – Installation Instructions Install Frame Mount Assemble Cross Bar Mount Locate Bed Support Rib Locate the bed support rib closest to the cab under Align the rear hole in the Frame Mount with the Thread an M10-1.5 Hex Nut onto an M10-1.5 x the truck bed.
Page 4
TrekStep Side-Mount™ – Installation Instructions All Models All Models Secure Frame Mount to Bed Except 2011 – Current Driver’s Side Except 2002 – 2008 1500 6.4' Bed Use an M10-1.5 Nylock Nut and an M10 Flat Assemble Adjustable Install Top Bracket...
Page 5
TrekStep Side-Mount™ – Installation Instructions Beds without Open Rib Beds with Open Rib Beds with Open Rib Secure Side Bracket to Secure Side Bracket to Rib Install Locking Block Locking Block Adjust the Side Bracket so it fi ts over the end Install an M8-1.25 U-Nut into the hole in the rib.
Page 6
TrekStep Side-Mount™ – Installation Instructions If Cross Bar Was Not Installed in Step 4 Adjustable Install Cross Bar and Linkage Side Mount Frame Put a drop of Loctite on the threads of two (2) M10- Mount Foot 1.5 x 45mm Hex Head Screws.
Page 7
TrekStep Side-Mount™ – Installation Instructions Install Step Step Adjustment Once the Step is installed on the vehicle, you may Use the M6-1.0 x 20 Socket Head Cap Screws to adjust it as desired. mount the Step to the Linkage Assembly.
TrekStep Side-Mount™ – Installation Instructions Operation Maintenance Tips • The TrekStep™ is foot operated and deploys and retracts with a The step pad surface and linkage arms can be washed with mild soap and nudge of your foot. water using a soft brush or sponge to dislodge any mud, dirt or accumulated road grime.