Advertisement
TrekStep™ – Installation Instructions
2014 – Current Models Only
Remove Plastic Rivet
Remove the plastic rivet in bottom of bumper that is
holding the bumper cap.
Remove Plastic Rivet
2014 – Current Models Only
Remove Bumper Bracket Bolts
Use an M12 wrench to remove the 2 bumper
bracket bolts on top of bumper.
Remove M12 Bolts
Rev. B 0223
2014 – Current Models Only
Release Bumper Clips
Remove bumper caps from bumper to
remove 2 bolts holding bumper bracket.
From the bottom side of bumper, use
a fl at head screwdriver to release clip
from bumper slot. Gently pull up on
bumper caps from the top until clips
come free of bumper.
There are a total of 10 clips that will
need to be removed from bumper.
The corner bumper cap will come
completely free, the center bumper
cap will only need to come up far enough to
reach the bumper bracket bolt.
2014 – Current Models Only
Remove Bumper Bracket
Remove the bumper bracket from vehicle. Store
the bracket to be used if the Step is removed.
Remove Bracket
Remove
Clips
Locate Rear Bumper Attachment
Locate the rear bumper attachment point on the
driver's side of the vehicle.
75505 pg. 3
Advertisement
