Table of Contents
Advertisement
Motion detector top unit Standard
Motion detector 1.10 m
–
Screen for limiting the detection area
Automatic operation
The device detects heat motions of people, animals and objects.
–
The light is switched on if a person enters the detection field and the bright-
ness threshold is below the set brightness threshold.
–
The run-on time restarts with each detected motion.
–
The light is switched off if:
no more movement is detected in the detection field and the run-on time has
elapsed or
the ambient light is too bright and the run-on time has elapsed.
To avoid any switch-on caused by a cooling lamp, no movement signals are evalu-
ated for a brief lockout time after switching off. The motion detector adjusts itself to
the ambient conditions to keep the time as short as possible.
Behaviour after a mains voltage failure
After mains voltage return, the device performs a self-test for a maximum of 60
seconds. After the self-test has been completed, the device is ready for operation.
The following applies during the self-test:
–
The load is switched on.
–
Movements are not detected
3
Operation
Precondition: A 2-wire or 3-wire extension with push-button cover or a push-button is
connected.
Multiple extensions can be combined with each other. Operation with the rotary dim-
mer extension is described in the rotary dimmer extension instructions.
Switching on light for the duration of the run-on time
￭
Press the push-button cover or push-button for less than 0.4 seconds.
Light is switched on depending on brightness and motion. Movements are
evaluated according to the brightness and prolong the run-on time.
If the push-button cover or push-button is pressed again in the switched-on
state, the run-on time is restarted. In combination with a dimming insert,
switch-on brightness is switched on again.
Dim the light
Only in combination with a main device with a dimming insert.
32599612
10870634
19.07.2023
4 / 14
Advertisement
Table of Contents
