Table of Contents
Advertisement
System 3000
Motion detector top unit 1.10 m Standard, Motion detector top unit 2.20 m
Standard
Behaviour after a mains voltage failure
After mains voltage return, the device performs a self-test for a maximum of 60 seconds. After
the self-test has been completed, the device is ready for operation.
The following applies during the self-test:
–
The load is switched on.
–
Movements are not detected
3
Operation
Precondition: A 2-wire or 3-wire extension with button cover or a push-button is connected.
Multiple extensions can be combined with each other. Operation with the rotary dimmer exten-
sion is described in the rotary dimmer extension instructions.
Switching on light for the duration of the run-on time
￭
Press the button cover or push-button for less than 0.4 seconds.
Light is switched on depending on brightness and motion. Movements are evaluated ac-
cording to the brightness and prolong the run-on time.
If the button cover or push-button is pressed again in the switched-on state, the run-on
time is restarted. In combination with a dimming insert, switch-on brightness is switched
on again.
Dim the light
Only in combination with a main device with a dimming insert.
￭
Press the button cover at the top or bottom or the push-button for longer than 0.4
seconds. Light becomes brighter or dimmer as far as the respective limit value.
Push-button: The dimming direction is changed with each new long actuation.
Save switch-on brightness
Only in combination with a main device with a dimming insert.
In the state as supplied, the switch-on brightness is set to maximum brightness.
￭
Set light to the required brightness.
￭
Press the button cover over entire surface for longer than 4 seconds.
Switch-on brightness is saved. For confirmation, the light is switched off briefly and
switched on again.
An push-button cannot be used to save the switch-on brightness.
Delete switch-on brightness
Only in combination with a main device with a dimming insert.
￭
Press the button cover briefly: Light switches on at the saved switch-on brightness.
￭
Press the button cover over entire surface for longer than 4 seconds.
The switch-on brightness is deleted. On switching on, the dimming insert switches to the
last set brightness value. For confirmation, the light is switched off briefly and switched on
again.
A push-button cannot be used to delete the switch-on brightness.
4
Information for electrically skilled persons
DANGER!
Mortal danger of electric shock.
Disconnect the device. Cover up live parts.
32599602
10865947
04.05.2018
2 / 9
Advertisement
Table of Contents
