Replacing Batteries; Disassembly And Disposal - Kalfire E one User Manual

The remote control is not responding: the
Bluetooth symbol is visible in the fireplace.
This indicates that there is no connection
between the remote control and the fireplace.
 Pair the remote control with the fireplace.
(See section 5.2.)
The remote control is not responding: the
red light at the top left of the remote
control is not lit.
 Replace the batteries of the remote control.
 The remote control is broken and needs to
be replaced.
7.1

Replacing batteries

If the red LED light in the upper right
corner of the remote control no longer
illuminates when you press any of the
buttons, the battery needs to be replaced.
Replace the battery in the remote control
as follows:
Grasp the remote control on-the-head

and turn it over.
Place your thumb as shown below.

Press the back lightly with your thumb

and slide the cover upwards at the
same time.
Replace the battery into the remote

control (1 x AAA)
Replace the cover in reverse order.

8 Technical data
Energy consumption per operating mode
Kalfire E-one 100/130
standby mode (W)
standby mode, incl. anti-reflect function
(W)
full operating mode*, excl. Atmos Heating
(W)
full operating mode*, incl. Atmos Heating
– level 1 (W)
full operating mode*, incl. Atmos Heating
– level 2 (W)
Energy consumption per operating mode
Kalfire E-one 160/190
standby mode (W)
standby mode, incl. anti-reflect function
(W)
full operating mode*, excl. Atmos Heating
(W)
full operating mode*, incl. Atmos Heating
– level 1 (W)
full operating mode*, incl. Atmos Heating
– level 2 (W)
*
*full operating mode: Dual HD Flame technology, Atmos
lighting max. hybrid LED E max, Kalfire Sound volume max.
8.1

Disassembly and disposal

Dismantle the device at the end of its
service life according to local laws and
regulations.
Remove the battery from the remote
control. Return used batteries to a disposal
point.
9,6
17
64
1066
2066
11
22,6
116
1115
2115