E-One Remote And Symbols; Bluetooth Pairing E-One Remote; Control - Kalfire E one User Manual

5 Operation Kalfire E-one
5.1

E-one remote and symbols

1. Hybrid LED E (Lower ember bed
intensity)
Dim Atmos Lighting
2. Increase flame height
3. Lower volume of Kalfire Sound
4. Adjust flame intensity
5. Atmos Heating (2 levels)
6. Mood 1
7. Mood 2
8. Power on/off
9. Atmos Lighting
10. Dynamic Atmos Lighting
11. Raise volume of Kalfire Sound
12. Decrease flame height
13. Adjust flame type
14. Adjust sound type
15. Mood 3
5.2

Bluetooth pairing E-one remote

When the fireplace is used for the first time,
the remote control will connect to it
automatically. If the following symbol is
projected on the rear screen of the fireplace,
the remote control must be paired manually.
Manual pairing is done by pressing the
and buttons on the remote control at
same time.
Release the buttons when a red LED light
flashes in the top-left corner of the remote
control. You will know when the remote
control is successfully paired with the E-one
when the Bluetooth symbol is no longer visible.
5.3

Control

Switching the fireplace on
Briefly press the on/off button. It takes about
30 seconds for the fireplace to fully start up.
Hybrid LED E intensity (No. 1)
Set the intensity of the ember bed beneath the
logs. Depending on ambient light and personal
preference, you can choose a low or higher
intensity. With each press of the button, a
higher level is activated. After reaching the
highest level (level 5), the cycle restarts with
level 0. At level 0, the ember bed is turned off.
Level 1 is then the level with the lowest
possible light intensity.