Modem Connect, Manual Connect - Valcom V-2926 User Manual

Direct Connect - Set Up Com Port
Select File, Com Setup, Com Port Selection.
If the port is known, use the down arrow to locate the number, select it and press OK.
If the port is not known, select Auto Find.
Reminder:
If direct connect is being used, make sure cables are connected and V-2924A is on.
If modem connect is being used, make sure modem is installed and working properly.
Modem Connect
From the Programming Tool, select File, Modem, and then Modem Connect.
The screen below appears. Enter the number to dial or select a phone number from the list displayed. Numbers can
be added, edited, or deleted from the list. Up to 10 numbers can be stored.
Once the desired phone number is displayed in the Number to Dial field, click on the Dial button. Messages should
be displayed stating, "Initializing", "Dialing", and "Modem Connection Successful". Click on OK.
If modem fails to connect, verify modem was set up properly during system installation. Refer to section titled,
"Setup of the V-2924A Modem," page 15.
12 947213