Download Print this page
Valcom V-2900 User Manual

Valcom V-2900 User Manual

One zone door answering unit

Advertisement

Quick Links

ONE ZONE DOOR ANSWERING UNIT
INTRODUCTION
The V-2900 Door Answering Unit provides voice
contact from a designated telephone station to a
door. When used in conjunction with a door
plate speaker, pressing the pushbutton on the
door plate speaker will cause the phone to ring
(1 second on, 4 seconds off). By answering the
call, the system user can converse with the
person at the door. (The telephone may also call
the door speaker).
The V-2900 can be used with a dedicated single
line telephone set, a loop start trunk port of a
PABX or C. O. Line Position of an E-Key
System.
Refer to Figure 1 for a block diagram of a typical
installation.
FEATURES
Loop start trunk access from a PABX or
C. O. Line Position of an E-Key system
Dedicated single line telephone access
Phone to speaker volume control
Speaker to phone volume control
Screw terminals for all connections
-24 Vdc powered (power supply included)
Built-in 30 Hz ring generator
Cycle ringing (1 second on, 4 seconds off)
Tone at speaker when button pressed to
access unit
Automatic cut-off after approximately 8 rings
or answer (whichever occurs first)

SPECIFICATIONS

Input Impedance:
Input Level:
Output Impedance:
Ring Supply:
Power Req.:
V-2900
600 Ohms
Nominally -10dBm
45 Ohms
90 Vac, 30Hz
-24 Vdc at 250 mA nom.
Dimensions/Weight
8.25"H x 4.5"W x 2.35"D
(20.96cm H x 11.43cm W x 5.97cm D)
Weight: 3.1 lbs. (1.41 kg)
Environment
Temperature:
Humidity:
ACCESS
E-Key or PBX Access
When using the V-2900 with an Electronic Key
system or PABX, the following equipment is
required:
1) 1 V-2900 Door Answering Unit
2) 1 C.O. Line Position (E-Key) OR
1 Loop Start Trunk Port (PABX)
3) 1 Door Plate Speaker
4) 1 -24 Vdc power supply (included)
Single Line Phone Access
When using the V-2900 with a dedicated single
line telephone, the following equipment is
required: (NOTE: A dedicated single line
telephone is one that is only connected to the
V-2900 Door Answering Unit. A single line
telephone may not be connected to both the
V-2900 and a central office line.)
1) 1 V-2900 Door Answering Unit
2) 1 Single Line Telephone (Dedicated)
3) 1 Door Plate Speaker
4) 1 –24 Vdc power supply (included)
1
Issue 4
0 to 50 Degrees C
0 to 85% non-precipitating
947291

Advertisement

loading

Summary of Contents for Valcom V-2900

  • Page 1: Specifications

    Dimensions/Weight  8.25"H x 4.5"W x 2.35"D The V-2900 can be used with a dedicated single (20.96cm H x 11.43cm W x 5.97cm D) line telephone set, a loop start trunk port of a  Weight: 3.1 lbs. (1.41 kg) PABX or C.
  • Page 2: Technical Assistance

    FIGURE 1 - SIMPLIFIED BLOCK DIAGRAM OPERATION INSTALLATION The V-2900 is a single talkpath unit which allows Remove the metal mounting plate from the rear an individual at a external location to converse of the V-2900 enclosure. Using two #6 3/4"...
  • Page 3 WIRE TIE LOOP TO REMOVE COVER WIRE TIE USED TO BUNDLE WIRES LOOSEN SCREW, ENTERING AND LEAVING TERMINAL AREA THEN ACTIVATE LATCH WIREWAY OPENING TO WALL PLATE AND .155 DIA. HOLES FOR MOUNTING TO JUNCTION BOX METAL WALL SINGLE OR DOUBLE GANG JUNCTION BOX MOUNTING HOLE PATTERN MATCHES BOTH EURO PLATE...
  • Page 4 VALCOM LIMITED WARRANTY Valcom, Inc. warrants its products only to the original purchaser, for its own use, to be free from defects in materials and workmanship under conditions of normal use and service for a period of one year from the date of shipment. This Limited Warranty obligation shall be limited to the replacement, repair or refund of any such defective device within the warranty period, provided that: 1.