Remote Engine Control - CrimeStopper EZEE START EZ-10 Operating Instructions Manual

REMOTE ENGINE STARTING - SUCCESSFUL START:
1) Press the remote start button for at least 1 second.
2) Parking lights flash once; return solid, and the Ignition/Acc circuits turn on.
3) After a few seconds the Starter Motor engages, Parking lights and Acc circuits will turn off while cranking.
4) Engine Starts and Runs. Parking Lights and Acc turn back on, Doors Lock.
5) Engine will remain running for programmed run time until it is reset with Brake pedal.
REMOTE ENGINE STARTING - UNSUCCESSFUL START
In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then
attempts to restart the engine a 2
of up to10 seconds maximum. This should provide ample cranking time for difficult starts, but is limited to 10
seconds to help prevent damage to the starter from over cranking.
1) If the engine starts on 2
2) If Third attempt fails to start engine, the system will turn off and doors will remain locked. NO FURTHER
ATTEMPTS WILL BE MADE AUTOMATICALLY
TURNING OFF A REMOTE STARTED ENGINE:
1) Engine is running in Remote Start (Parking lights ON).
2) Press and release the remote start button
3) Engine & parking lights OFF.
EZ-30 MODEL ONLY: REMOTE START RUN TIME RESET:
You can reset the engine-run timer to allow for more running time after remote start has already occurred
using the remote control. After a successful remote start, press both the Lock & Unlock buttons together for at
least 2 seconds. The parking lights will flash 3 times and the internal engine timer will reset back to zero
4
minutes.

REMOTE ENGINE CONTROL

FLASH 1X
IGN
THEN
SOLID
nd rd
and 3 time. For hard starting engines, the unit will allow a starter crank time
nd rd
or 3 attempt, see steps 4 & 5 above of "Successful Start".
AFTER
3
STARTER
SEC.
SOLID