Status Led; Remote Engine Control - CrimeStopper EZEE Start EZ-3 Operating Instructions Manual

LED Operation: (Optional, requires Installation of LED)
LED will flash when locking your doors with remote.
LED will remain solid in Valet Service Mode.
Remote Start & Auxiliary Output – Button Press Selection (Option # 6):
To eliminate the possibility of accidentally opening the trunk or starting the vehicle, there are (3) options for button
press selection. This option will allow you to change whether the Remote starter and Trunk release activate by a:
1. Double button - ½ second presses.
2. *Single ½ second press (Default).
3. Press and Hold 2 seconds.
*Default = 1 single press*
REMOTE ENGINE STARTING - SUCCESSFUL START:
1) Press the remote start button for at least 1/2 second (*default). Parking lights flash once, return solid, and the
Ignition/Acc circuits turn on.
2) After a few seconds the Starter Motor engages. The parking lights and Acc circuits will turn off while cranking.
3) Engine Starts and Runs. Parking Lights and Acc turns back on, and the doors lock.
4) Engine will remain running for programmed run time until reset with Brake pedal. If needed, the engine can be
turned off with remote transmitter by pressing and releasing the Start button.
FLASH 1X
THEN
SOLID

STATUS LED

REMOTE ENGINE CONTROL

IGN
4
AFTER
4
STARTER
SEC.
SOLID