Status Led; Remote Engine Control - CrimeStopper RS1-G4 Cool Start Operating Instructions Manual

VEHICLE STATUS LED : Used for Remote Start Diagnostics – page 13 (Install optional)
The optional LED will remain solid when the system is in Valet Service mode. The remote start function WILL
NOT operate when in Valet Mode. See page # 10 for Valet Mode.
REMOTE ENGINE STARTING - SUCCESSFUL START:
1) Press the remote start button for at least 1/2 second (*default). Parking lights flash once, return solid, and the
Ignition/Acc circuits turn on.
2) After a few seconds the Starter Motor engages. The parking lights and Acc circuits will turn off while cranking.
3) Engine Starts and Runs. Parking Lights and Acc turns back on, and the doors lock.
4) Engine will remain running for programmed run time until reset with Brake pedal. If needed, the engine can be
turned off with remote transmitter by pressing and releasing the Start button.
FLASH 1X
THEN
SOLID

STATUS LED

REMOTE ENGINE CONTROL

IGN
4
AFTER
4
STARTER
SEC.
SOLID