Transmitter Programming - CrimeStopper EZEE START EZ-10 Operating Instructions Manual

Crimestopper security products operating instructions remote engine starting system ez-30,ez-10

Hide thumbs Also See for EZEE START EZ-10:

Table of Contents

BRAKE PEDAL RESET

Prevents starting or shuts off a remote started vehicle when this circuit is active or activated. Prevents

unauthorized tampering. This circuit shuts the system down immediately when brake pedal is pressed if the key is

not in ignition and turned to the ON position.

OEM ALARM INTERFACE

This feature is designed to Disarm and Re-arm Factory equipped security systems in conjunction with remote start

and keyless entry (if needed for your vehicle). This feature will maintain the original integrity and security of your

vehicle's factory equipped systems before, during, or after remote start.

NOTE:

When changing, charging, or jumpstarting the vehicle's battery we recommend removing the main power fuses

located on the heavy gauge RED wires near the remote start module.

Note: All transmitter codes must be learned at time of programming!! The EZEE systems learn up to 4

different transmitter codes.

1. Open Hood (If no hood pin installed with your system, then you must ground the Gray Hood pin wire).

2. Turn key to the ON position.

3. Press Programming button 4 times, then after a few seconds the unit flashes the parking lights 4 times.

4. Press Lock Button #1 of the transmitter to be coded. EZ-10 MODEL: Press Engine Start Button. You should

get 2 light flashes indicating the unit is waiting for a 2

unit will flash 3 times indicating its waiting for the 3

automatically exit code learning mode, otherwise turn key off and close hood. See diagram next page.

CONVENIENCE AND SAFETY FEATURES

TRANSMITTER PROGRAMMING

code, then press button #1 of a second transmitter, the

code and so on. If all 4 codes are learned, the unit will

Table of Contents

Ezee start ez-30