Harness Attachment; Attach V-Tec Single Leg Pfl To Harness; Attach V-Tec Twin Leg Pfls To Harness With V-Tec Twinlink Connector - MSA V-TEC PFL User Instructions

PFL Materials
Component
Case
Drum
Chassis, Pawl, Swivel Assembly,
Main Spring
Lifeline
Connectors
4

Harness Attachment

WARNING!
DO NOT rely on feel or sound to verify proper connector engagement. Ensure the
connector is closed before use.
Failure to follow this warning can result in serious personal injury or death.
4.1 Attach V-TEC Single Leg PFL to Harness
A V-TEC PFL may be connected to an approved full body harness by feeding the
carabiner through the back D-ring of the harness. In these applications, the
snaphook is connected to a suitable anchorage with the appropriate connecting
hardware.
4.2 Attach V-TEC Twin Leg PFLs to Harness with V-TEC TwinLink
Connector
A V-TEC TwinLink connector can be used to connect two V-TEC PFLs side-by-side
on a full body harness just below the rear D-Ring or through the PFL tunnel. The V-
TEC TwinLink connector shall only be used to connect a maximum of two V-TEC
PFLs to the harness.*
* The V-TEC TwinLink (minus the clip) may be used to attach directly to a full body harness D-ring.
US
Standard Material
Polycarbonate
Stainless Steel / Nylon
Stainless Steel
2/3" (17 mm) wide / 0.06" (1.4 mm) thick
HMPE
Steel OR Aluminum
V-TEC® PFL
4 Harness Attachment
9