Wall Mounting - Huawei SmartGuard-63A-S0 User Manual

SmartGuard-63A-(S0, AUS0)
User Manual
● Move the SmartGuard with care to prevent device damage and personal injury.
● Do not use the wiring terminals and ports at the bottom to support any weight
● When you need to temporally place the SmartGuard on the ground, use foam,

4.6 Wall Mounting

Procedure
Step 1 Determine the positions for drilling holes using the marking-off plate, level the
holes using a level, and mark the positions using a marker.
Step 2 Secure the mounting bracket.
Avoid drilling holes into the water pipes or power cables buried in the wall.
Figure 4-4 Expansion bolt composition
(1) Hexagonal
bolt
Issue 03 (2023-12-27)
CA UTION
of the SmartGuard.
cardboard, or other protection material to prevent damage to its enclosure.
D ANGER
NO TE
● M6x60 expansion bolts are delivered with the product. If the length and number of the
bolts do not meet installation requirements, prepare M6 stainless steel expansion bolts
by yourself.
● The expansion bolts delivered with the product are used for solid brick-concrete walls. If
other types of walls are used, ensure that the load-bearing capacity requirements are
met and appropriate bolts are selected.
● To prevent installation failure of expansion bolts due to excessive deviation of holes on
brick-concrete walls, you are advised to use small drill bits or other mounting brackets
such as plastic anchor bolts to ensure reliable installation. The service life of the
mounting brackets shall be at least 10 years.
(2) Flat washer
Copyright © Huawei Digital Power Technologies Co., Ltd.
(3) Sleeve
4 System Installation
(4) Conical nut
31