Table of Contents
Advertisement
Locomotive basics
Adding fluid to your locomotive's smoke generator continued
Stack Smoke
Loading smoke fluid into the smoke stack will provide
smoke fluid for the stack smoke effect. When adding fluid
DO NOT EXCEED 20 DROPS per unit as this can cause your
smoke unit to become oversaturated allowing leakage onto the
electronics. Note that operating your locomotive's smoke unit
without smoke fluid will cause damage to the heating element.
Add 20 drops initially and 10 to 20 thereafter, as required to
maintain desired smoke.
Note!
Your locomotive's smoke fluid consumption will vary
depending on the smoke level setting you have selected.
Refer to Figure 5 as you add the smoke fluid. If you prefer to operate your locomotive without
smoke, locate the smoke unit switch under under the cab of the locomotive and slide it to the OFF
position. Refer below for the location of the switch.
Locomotive switch locations
T
he functions of your LionChief Plus 2.0 locomotive's switches are outlined below. The
instructions below are specific to this particular locomotive; note that available fea-
tures (and switches) may differ from other locomotives and sets.
Smoke Switch
Used to turn the smoke unit on
and off.
Program / Run Switch
Used to assign an ID# and
reprogram the locomotive in
Command operation when the
switch is in the PROG position.
Also used to "lock" your locomotive
in a single direction, or neutral,
in conventional operation when
the switch is placed in the PROG
position.
Bluetooth Switch
Used to turn the Bluetooth
module on and off.
Bluetooth
switch
Program/Run
switch
Figure 6. Switch locations
8
O R
Figure 5. Stack smoke location
Smoke
switch
Advertisement
Table of Contents
