Front: Panel Facilities Icc Cscs Codes Ccesceschccvcevew Cman Vocuanaeh Covcbech Uc Ecuusck Gat Cadeccsecdctetaanlees Oaauves - Pioneer VSX-D1S Operating Instructions Manual

FRONT PANEL FACILITIES
FRONT PANEL FACILITIES
@O® © ©
@ POWER STANDBY/ON switch/indicator
This is the switch for electric power.
ON ........ .... When set to the ON position, power is supplied and the
unit becomes operational.
STANDBY .. When set to STANDBY position, the main power flow is
cut and the unit is no longer fully operational. A minute
flow of power feeds the unit to maintain operation
readiness.
The STANDBY indicator lights when the power is STANDBY, and goes
out during ON.
@ Remote sensor window
@ CUSTOM MEMORY SELECT switch
Recall a genre name with this switch.
@) MEMORY SCAN switch
Operates when the INPUT SELECTOR is set to TUNER. Station
frequencies assigned to the STATION CALL switches are tuned in, one
after another, beginning with the current station no., for approximately
5 seconds each. The display section SCAN indicator will light. Press
the switch again and the tuner remains tuned in to the station playing
when the switch was pressed the second time.
Station frequencies not assigned station numbers in the memory are
skipped.
When you have selected a CUSTOM MEMORY genre, memory scan
is performed on the stations in that genre.
(5) Display section (see page 23)
© STATION CALL (RANDOM 30 CH) switches
*® These switches are used to preset and recall desired broadcasting
Stations, ''AUTO/MONO" switch setting.
Station call operation example:
If you press the [*2] key:
* One time — station 2 is selected.
* Two times — station 12 is selected.
* Three times — station 22 is selected.
OO DM OBoO®
NOTE:
Pressing the STATION CALL switches when a component other than
TUNER is selected causes the INPUT SELECTOR setting to switch to
TUNER.
* They are also used when performing direct access tuning,
@ SURROUND MODE switches (See page 6)
DSSS (Digital Simulated Stereo System) switch
Operate this when inputting a monaural signal to enjoy a smulated
stereo sound. You can use it when a monaural signal is inputinto both
the left and right channels or when a monaural signal is inputinto only
one of the channels.
@ RETURN switch
Pressing this switch returns the receiver to the following setings, the
sound level being controlled by MASTER VOLUME control trob.
¢ TAPE 2 MONITOR OFF
® SURROUND MODE OFF
© SPEAKERS A ON
¢ MUTING OFF
¢ BALANCE CENTER
e INPUT SELECTOR TUNER
© STATION CALL 1 CH *
e VIDEO ADAPTOR OFF
* When a station is not memorized in 1 CH, station sarch will
automatically proceed from the frequency displayed.
(0) MASTER VOLUME control
Use to adjust the sound volume from the front, center and rear jpeakers,
When you adjust volume by remote control, the indicator ove the
knob flashes.
When the MULT! ROOM & SOURCE switch is ON, volume levi ism room
B cannot be adjusted with this knob. Adjust the volume b; remote
control.
19
<ARi1 272>