Before Operating, Adjust The Position Of These Switches; Features Coscssesvsess Ji25S Waker Nie Itaciae Tes Eiieuee Pinecteadivtes Wedieaetata Ren Vdeesy Old Ce Aeadag Eek Eeebeereeaieeed - Pioneer VSX-D1S Operating Instructions Manual

BEFORE OPERATING, ADJUST THE POSITION OF
THESE SWITCHES
TWO VOLTAGE SELECTOR SWITCHES
Only multi-voltage models are provided with these switches. U.S.,
Canadian, European, U.K. and Australian models are not provided with
these switches.
Mains voltages in Saudi Arabia are 127 V and 220 V only. Never use
this modei with 110 V setting in Saudi Arabia.
The line voltage selector switches are on the rear panel. Before your
model is shipped from the factory, these switches are set to the power
requirements of the destination. Check that they are set properly before
plugging the power cord into the household wall socket. If the voltage
is not properly set or if you move to an area where the voltage
requirements differ, adjust the selector switches as follows.
1. Use a medium-size screwdriver.
2. First, insert a screwdriver in the groove of the voltage selector at
the right, and adjust so that the tip of the groove points to the voltage
value of your area.
3. Next, insert a screwdriver in the groove of the voltage selector at
the left and adjust until the voltage is the same as at the right.
TWO VOLTAGE SELECTORS
CAUTION: TWO VOLTAGE SELECTORS
2
CHANNEL STEP/FM DE EMPHASIS SWITCH
(Not available on U.S. and Canadian models)
The unit has been factory preset to the channel allocation and de-
emphasis value for the area in which it is to be sold. If these values are
set incorrectly, the frequency display may stop at the wrong frequency,
or sound may be distorted, resulting in an inability to reproduce reception
signals at their proper sound quality. For this reason, be sure to confirm
that the values are set correctly before first using the unit.
[100kHz/10kHz/75zs] position:
Set to this position for areas with an FM reception step of 100kHz, AM
10kHz, and de-emphasis 75ys.
[S5O0kH2/9kHz/50us] position:
Set to this position, for areas with an FM reception step of 50kHz, AM
9kHz, and de-emphasis 5Ous.
NOTE:
When unsure about the channel allocation and de-emphasis values for
your area, consult your dealer for correct information.
CHANNEL STEP
/FMDE-EMPHASIS
acitov| A
a
220V
110V
120V-127V y40V
Pr : D
20V-127V
29N
Medium-size NOTE:
screwdriver
VOLTAGE SELECTORS
SOkHz/5OxS ff [100kHz/75uS FM
10kHz SkHz =a AM
Both switches must be in the same switch
setting; otherwise, unit can be damaged.
FEATURES
e DOLBY PRO LOGIC SURROUND performed by a
Digital Signal Processor (DSP).
¢ DSP provides five Sound Field Control (SFC) simulated
surround settings.
© Multi-Room & Source
Using this unit in combination with the optional MR-100 Multi-Room
System Remote Control Sensor Unit lets you enjoy different sources
in different rooms at the same time.
4
< ARB1272>
© Independent tone control of front, center, and rear
channels is possible.
You can make tone adjustments to front (L, R), center, and rear (L, R)
channels independently, for much finer control over sound quality.
¢ AM beat reduction
* Equipped with the JOG dial, designed ior easier
operation.
* Audio/Video programmable remote control unit.