Pioneer VSX-D1S Operating Instructions Manual page 46

REMOTE CONTROL
PROGRAMMING
@) LEARN indicator
This indicator lights when the Learn function is activated.
ON: Learning is possible.
OFF: Regular remote control functions can be performed.
NOTE: If the LEARN indicator flashes, this indicates that the program
Capacity is exceeded and that the last command is not memorized.
@) LEARN selector switch
This can be set as follows:
LEARN:
This position is used for storing the codes of your remote control unit.
USE:
Set to this position after codes have been stored in the LEARN position.
(Set to this position when using memorized commands.)
SR RECALL:
Set to this position when transmitting Pioneer unified remote control
code signals (Marked on the remote contro! unit).
46
<ARB1272>
[Operation example]
1. Set the LEARN switch of the programmable remote control unit to
the LEARN position and set the TRANSMIT mode selector switch
to the VIDEO position.
* Programming is possible with the TRANSMIT mode selector
switch in any position, but VIDEO is used as an example.
2. Place the transmission sections of the programmable remote contro!
unit and the remote contro! of the VCR facing each other.
1to2 i dal eel
7" ioe
bere ee orn,
¢ Place the two units on a table, separated by 2 to 5 cm (1 to 2
inches).
Memorization will not be possible if they are too close.
3. Hold down the VCR PLAY key of the Programmable remote control
unit until the LEARN indicator light up, then release the key.
4. Hold down the PLAY key of the VCR remote control unit.
5. Release the key of the VCR remote control unit after making sure
that the LEARN indicator has gone out on the Pioneer remote control
unit.
NOTE:
If the LEARN indicator flashes, it indicates that you are trying to preset
@ key not available for the learning function, or otherwise the program
capacity has been exceeded, the function programmed last will not be
memorized correctly. All previously programmed functions, however,
will be retained in memory and may be used as they are if the last
function is not essential. For re-programming refer to page 47
"Returning to the Initial Settings."'
yp eoueg Seen
| cue yououD Seen F i
wUUED
; a are es mS UEME
vu ine uA
6. Set the LEARN selector switch of the programmable remote control
unit to the USE position.
© The previous code (Pioneer uniform remote control code or code
for other equipment) is erased and replaced by the new code.
7. Check that the program works.
* Try actual operation and make sure the unit works properly.
¢ If the VCR does not operate when pressing the key, change angle,
position and distance between the remote contro! units and repeat
the programming procedure.
¢ When programming, make sure that the function indications (for
example, > , me, ™) on the other remote control unit and the
programmable remote control unit are the same. This will facilitate
operation.
NOTE:
Be careful when using the learn function because signafs from the
transmitting remote control unit may be reflected from walls or the
ceiling, and may arrive at the sensor of a component other than the
programmable remote control unit. It's a good idea to remove the tape
from a cassette deck or VCR in case they are accidentally activated.
It is also preferable to unplug the power cords of systern components
from power outlets, or cover the remote sensors of remote controlled
components to prevent accidental operation.