Pioneer VSX-D1S Operating Instructions Manual page 47

PROGRAMMING
REMOTE CONTROL
Questions and Answers about the Learning Function
Q: The remote control unit of my VCR has two REC (recording) keys.
They both have to be pressed at the same time to start recording.
What is the learning procedure in this case?
A: Hold one of the keys on the programmable remote control depressed
(for example the VCR @ key) until the LEARN indicator lights up,
and then press the two keys on the VCR remote control
simultaneously.
Q: The remote control unit of my VCR has a REC (recording) key and
a PLAY (playback) key and they both have to be pressed at the same
time to start recording. What is the learning procedure in this case?
A: Hold one of the keys on the programmable remote contro! depressed
(for example the VCR @ key) until the LEARN indicator lights up,
and then press the REC and PLAY keys on the VCR remote contro!
simultaneously.
* As described above, operations which require two keys to be
pressed at the same time are programmed by pressing the two
keys simultaneously.
Operating other equipment using the programmable
remote control unit
1. Set the LEARN switch of the programmable remote control unit to
the USE position.
2. Set the TRANSMIT mode selector switch to the desired position
(AUDIO/VIDEO/AUX).
© Set to the VIDEO position for programming as described in the
example.
3. Press the key of the desired function.
© The TRANSMIT indicator lights up while the remote control unit
is sending codes.
NOTE:
© When operating programmed keys, always set the LEARN switch to
the USE position. Operation is not possible in the LEARN position.
© For functions which require two keys to be pressed at the same time
{recording etc.) or functions for which several codes are sent
simultaneously (auto functions, timer programming, etc.) the
programming procedure is different and improper operation may
occur.
Returning to the Initial Settings
1. Set the LEARN selector switch to the LEARN position.
2. Remove the battery cover.
Cover
Sao
3. Press any of the keys available for programming. The LEARN
indicator will illuminate.
4. Use a ball-point pen or similar object to press the RESET button while
the LEARN indicator is flashing.
Reset button
© The programmed functions for the AUDIO, VIDEO and AUX
positions are cleared, and the remote control unit is reset to the
Pioneer uniform remote control codes.
¢ Press the button gently; do not use excessive force.
The following is the summary of the remote function modes. It is
noteworthy that the unit can learn audio or video type of commands
regardless of the setting of the transmit mode. This means you can
program audio commands while the mode selector switch is on video
and vice versa.
TRANSMIT MODE SELECTOR SWITCH
VIDEO
SR RECALL | Operate all audio sections of this Operate the video sections of this Operations only the amplifier and
receiver and other Pioneer components. | receiver and other Pioneer components. | surround sections.
Learn commands from different audio | Learn commands from different video | Learn additional audio or video
brands. brands. commands.
Operate audio components of different | Operate video components of different | Operate the extra audio-video
brands, using the programmed (learnt) | brands, using the programmed {learnt) | commands learnt.
commands.
commands.
47
<ARB'2 72>