Tool Preparation - Harwin Z80-255 Instruction Sheet

IS-46
Instruction Sheet for Z80-255 Hand Crimp Tool

TOOL PREPARATION

Changing from right to left hand operation
If the locator is fitted, please see section "Troubleshooting – Replacing the Dies" on page 6 for
instructions on removing the locator.
Ensure that the crimp
tool is at the fully
open position.
Assembling the Locator
Ensure that the crimp
tool is at the fully open
position.
Rotate the locator down, snapping the lower tabs on the locator
Issue: 3 Date: 01/02/2023 C/Order: 32102
Remove the TX-10 TORX head
screws holding the die sets in
Push down the centre insert of the
locator, as far as it will go.
into the bottom slots on the tool.
place.
Reverse the die sets, ensuring
that the small locating marks
line up and are on the outside
of the tool.
Insert the top hooks of
the locator into top
slots of the tool frame.
Correct position for
the locator.
3