Harwin Z80-294 Manual

HAND CRIMP TOOL Z80-294 (M22520/1-01)
Selector Index
This Hand Crimp Tool has been designed for use with the following Datamate Mix-Tek Power Crimp
Sockets [when used with Positioner Z80-295 (TP1663)]:
M80-338 .......................... Male power crimp contact for 18 AWG wire
M80-328 .......................... Female power crimp contact for 18 AWG wire
M80-339 .......................... Male power crimp contact for 20 AWG wire
M80-329 .......................... Female power crimp contact for 20 AWG wire
The Hand crimp tool M22520/1-01 consists of a basic hand tool, which should be used with a positioner.
The contact is correctly crimped when the tool is free to open at the fully closed position, i.e., when the
ratchet releases. The tool cannot be opened without completing the cycle.
Harwin North America
T: +1 603 893 5376 F: +1 603 893 5396
E: misboston@harwin.com W: www.harwin.com
IS-29 Issue: 4 Date: 16.12.2010
Retainer Ring
(Used in Mix-Tek male crimp connectors).
(Used in Mix-Tek female crimp connectors).
(Used in Mix-Tek male crimp connectors).
(Used in Mix-Tek female crimp connectors).
GENERAL INFORMATION
Harwin Europe
T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590
E: mis@harwin.co.uk W: www.harwin.com
C/Note: 11057
Tool in Closed Position
Selector Knob
Spring Clip
E: mis@harwin.com.sg W: www.harwin.com.sg
Harwin Asia
T: +65 6 779 4909 F: +65 6 779 3868
Page 1 of 3