Table of Contents
Advertisement
IS-46
Instruction Sheet for Z80-255 Hand Crimp Tool
Replacing the Dies
If you need to remove the dies to clean the tool, or replace the dies due to damage, then this
section will tell you how to first remove the locator and then the dies.
If you need to replace the die-set, spare die-sets are available from Harwin. Please request Part
Number Z80-244.
A) Remove the Locator:
1.
Ensure that the crimp tool is at the
fully open position.
3.
Lift the bottom of the locator and
swing it away from the tool.
B) Remove and Replace the Die Set:
See the instructions under section "Tool Preparation – Changing from Right to Left Hand
Operation", on page 3.
C) Replace the Locator:
See the instructions under section "Tool Preparation – Assembling the Locator", on page 3.
Issue: 3 Date: 01/02/2023 C/Order: 32102
2.
Squeeze gently on the lower area of
the locator shown in the above
picture, with your thumb and index
finger.
4.
The upper hooks should slip out of the
top slots easily.
10
Advertisement
Table of Contents
