Advertisement
Rotate the locator down, snapping the lower tabs on the locator
into the bottom slots on the tool.
1.
Ensure that the wire to be crimped is within the specified range of sizes for the contact and
the crimp tool. Failure to use the specified wire size will result in poor quality crimps and
possible tool damage.
2.
Cut the end of the cable to be terminated so that there is a clean cut end (Figure A). Strip
the cable to the correct length (Figure B) using a PTFE Wire stripper, preferably with
adjustable rotating cutter. This should result in all the strands laying together neatly. If the
lay of the strands is disturbed, it may be re-imposed with a slight twist.
Clean cut
Ø1.10mm max
Figure A
1.
Ensure that the crimp
tool is at the fully
open position.
IS-27
Issue: 3
Date: 21.01.09
WIRE PREPARATION
CRIMPING PROCEDURE
2.
Push the button on the back of the locator, which will
move the locator forward between the crimp dies.
C/Note: 10269
Correct position for the
RIGHT
2.50 – 3.00m m
Figure B
locator.
W RONG
Page 3 of 7
Advertisement
