Harwin Z80-255 Instruction Sheet page 5

IS-46
Instruction Sheet for Z80-255 Hand Crimp Tool
3. Whilst holding the locator in the forward
position, insert the crimp contact into
the correct locator nest. The wire size is
marked on the crimp die, above each
location.
4. Release the locator button, allowing the crimp contact to move
back between the crimping jaws.
5. Close the handle, until the second ratchet position engages.
6. Load the stripped wire through the terminal, and against the wire
stop inside the tool.
7. Whilst holding the wire against the wire stop,
complete the crimp by squeezing the tool handles
together through the rest of the ratchet clicks –
another 3, to make 5 in total. The handles should
then be free to open. Remove the crimped wire.
Issue: 3 Date: 01/02/2023 C/Order: 32102 5