Transmitter Programming - CrimeStopper Super Rage CS-2011RS IV Series Operation Instructions Manual

Remote control alarm & remote engine starting system

Hide thumbs Also See for Super Rage CS-2011RS IV Series:

Table of Contents

Note: Remotes Transmitters come pre-programmed from the Factory. When re-learning remotes or

adding remotes, ALL your system's remote codes must be learned at time of programming!! This

system allow storage of up to 4 different remote codes in memory.

1. Open hood (ground the Blue hood pin wire if no hood pin is installed.)

2. Turn key to the ON position. (Starting the vehicle is not necessary.)

3. Press Program/Valet button 4 times. After a few seconds, the unit will flash the parking lights 4 times.

4. Press Button #1 (Lock) of the transmitter to be learned. You should get 2 light flashes indicating the code-

learn. Now the unit is waiting for a 2

The unit will flash the lights in succession after each code learned for up to 4 codes. (2 flashes for the 2

code, 3 flashes for the 3

mode, otherwise turn key OFF and close the hood.

(BLUE WIRE GROUNDED)

TRANSMITTER PROGRAMMING

code, so repeat this step as needed with up to 3 additional remotes.

code etc.) If all 4 codes are learned, the unit will automatically exit code learning

OFF

START

FLASH 2, 3, or 4 X's

IGN

PRESS 4X's

OFF

WAIT FOR

4 FLASHES

IGN

Table of Contents

Cs-2011rs.iv