Anti-Carjack Protection; Transmitter Programming - CrimeStopper CS-2011RS.II Operation Instructions Manual

Remote control alarm & remote engine starting system

Hide thumbs Also See for CS-2011RS.II:

Table of Contents

SWITCH-CONTROLLED CARJACK:

This configuration will enable the vehicle owner to activate a Carjack countdown by pressing a hidden push-

button (not included with kit) during a Carjack situation. A Carjack countdown will begin under the following

conditions: Ignition is ON (vehicle is running), the push-button is pressed, and the door opens/closes. Upon

these 3 events, in that order, the alarm will start a Carjack countdown. After a delay of one minute, the system

will begin chirping for 20 seconds then trigger into a full cycle for up to 5 minutes. To reset this Carjack mode,

Ignition must be ON then press and hold the override/valet button for 5 seconds (until LED goes out.)

FULL-TIME [Permanent] CARJACK:

We recommend that this configuration only be used in serious situations. When the Ignition is on (vehicle is

running), anytime a door is opened the Carjack countdown sequence will be initiated. There will be 2 light

flashes and the LED will change from solid to quick pulsing as confirmation of a countdown sequence. To

reset FULL TIME Carjack, the Ignition has to be ON, then press and hold the override/program button 5

seconds until LED stops pulsing. The LED will be on SOLID when in this mode anytime the Ignition is ON (or

while driving) as a reminder that Carjack is waiting for a door to open.

Note: All transmitter codes must be learned at time of programming!! Up to 4 different transmitter

codes can be stored in the memory of the system.

1. Open Hood (Ground the Blue wire if no hood pin is installed.)

2. Turn key to the ON position.

3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.

4. Press button #1 (Lock) of the transmitter or transceiver to be learned. You should get 2 light flashes

indication the unit is waiting for a 2

unit will flash 3 times indicating its waiting for the 3

codes are learned, the unit will automatically exit code learning mode, otherwise turn key off and close

hood.

DIAGRAM ON NEXT PAGE

ANTI CARJACK PROTECTION

code, then press button #1 of a second transmitter or transceiver, the

code and lights will flash 4 times for 4

code. If all 4

Table of Contents

Super rage cs-2011rs series ii