Room Number And Bed Letter - Datascope Accutorr Plus Service Manual

1.3.2.3 Room Number and Bed Letter
To monitor more than one patient, assign each patient to a particular room number and
bed letter. Use che ROOM/BED key (24) to set the room number from 0 to 99 and the
bed letter as a, b, c or d. On initial power up (no stored patient data), che room number
and bed lerter default to 0,a.
1. Press the ROOM/BED key (24). The
ROOM LED flashes indicating that the Press to increase or
decrease the Room
room number can now be changed. SE Number and Bed Letter
PATIENT INFO.
2. Press the Patient Info. Up or Down Arrow
1a e
key (27 & 28) to increment or decrement 0 0 Press to change
Fu esp
*
the Room Number
the room number.
and Bed Letter
worm OA
3. Press the ROOM/BED key again. The
Figure 1-9 - Room Number and Bed Letter
BED LED flashes.
Keys and Indicators
4. Press the Parient Info. Up or Down Arrow
key (27 & 28) to increment or decrement
the bed letter.
5. Press the ROOM/BED key a third time
to exit this mode, or do not press the
key for 15 seconds.
Once measurements have been taken, and the
unit is powered off and on, the room number
and bed letter will default to the lowest room
and bed where data is currently stored.
Accutorr Plus Service Manual
Chapter 1, Operation