Table of Contents
Advertisement
Operation When Receiving a QSY
When QSY (frequency) information is received, the station list
appears with the verified frequency.
1 Select [Tune], and press [A/B].
• The frequency is set in the voice channel (non-data
band).
Note:
¡ When using 6.5 kHz or 12.5 kHz step values, the display does
not indicate values for 100 Hz and lower.
¡ If D-STAR repeater information is included in the QSY
information of the received beacons and when the voice
channel (non-data band) is in DR mode, the QSY function will
be activated even outside the range of distance limit. Gateway
communication will be configured automatically.
SETTING SmartBeaconing
Set to use "SmartBeaconing" (Menu No. 510) with APRS data
transmission.
This function optimizes beacon transmission based on driving
direction and speed. Use this function when you want to
track your transmissions, especially for optimizing crossover
beacon transmission intervals.
When using smart beaconing, set Menu No. 571 (TX Beep) to
[On] (default value) to confirm the transmission status of the
beacon.
< SmartBeaconing™ from HamHUD Nichetronix >
Low Speed/ High Speed
1 Access Menu No. 530.
2 Select the Low speed and High speed.
• Low speed setting (2 ~ 30 <mi/h, km/h or knots>). When
the speed is lower than this, beacons are transmitted at
the time interval specified under "Slow Rate".
• High speed setting (2 ~ 90 <mi/h, km/h or knots>). When
the speed is faster than this, beacons are transmitted at
the time interval specified under "Fast Rate".
Note:
¡ To select the speed setting of the units, access Menu No. 970
(Speed, Distance).
TM
Slow Rate
Low speed transmission interval time.
1 Access Menu No. 531.
2 Select from [1] to [100] minutes.
Fast Rate
High speed transmission interval time .
1 Access Menu No. 532.
2 Select from [10] to [180] seconds.
Turn Angle
Driving direction change, minimum value setting.
1 Access Menu No. 533.
2 Select from [5] to [90] degrees.
Turn Slope
Driving direction change, additional value setting.
1 Access Menu No. 534.
2 Select from [1] to [255] (10degrees/speed).
14-17
Advertisement
Table of Contents
