Table of Contents
Advertisement
Storing Simplex and Standard Repeater Frequencies
1 Select the frequency, mode, etc.
2 Press [F], [MR].
Memory channel registration screen appears on the
display.
3 Select the memory channel number.
4 Press [ENT].
The simplex channel is registered.
Storing Odd-Split Repeater Frequencies
When you change the RX and TX frequencies, register the RX
frequency first and then register the TX frequency. Only the TX
frequency cannot be registered.
1 Register the RX frequency.
A split channel can be registered only to an already
registered memory channel.
2 Display the TX frequency.
3 Press [F], [MR].
Memory channel registration screen appears on the
display.
4 Select the memory channel number.
5 Press [A/B].
The split channel is registered.
Note:
¡ You cannot set the TX and RX frequencies on different
frequency bands.
Clearing a Memory Channel
You can clear the specified channel of the registered memory
channels.
1 Press [MR] to enter the memory mode.
2 Press [ENT].
The memory channel list appears. You can also access to
the memory channel list by Menu No. 200.
3 Select the specified channel and press [MENU].
The memory channel list menu appears.
4 Select [Clear Memory] and press [A/B].
A confirmation message appears on the display.
•
Press [MODE] to return to the memory channel list
menu.
5 Press [A/B].
The specified memory channel is cleared.
To clear another memory channel, repeat the procedure
from step 3.
RECALLING A MEMORY CHANNEL
You can recall a memory channel in the order of the channel
number or select from a memory channel list.
Recalling in the order of memory channel number
1 Press [MR] to enter Memory Recall mode.
2 Press [
]/[ ] or rotate the [ENC] control to select your
desired Memory channel.
•
Additionally, you can enter a channel number using the
keypad.
Recalling from the memory channel list
1 Press [MR] to enter Memory Recall mode.
Memory channels in the current frequency band or all
memory channels will be recalled according to the setting
in menu No. 202.
2 Press [ENT].
The Memory channel list appears.
3 Press [
]/[ ] or rotate the [ENC] control or enter a
3-digit channel number using the keypad.
The entered memory channel number will appear at the
top of the list. When the memory channel number is two
digits or less, press [ENT] after the number.
4 Press [ENT].
The selected channel is configured and the screen returns
to the frequency display.
Note:
¡ When a split channel is recalled, "±" appears on the display.
¡ A memory channel number cannot be recalled by keypad input if
the memory channel is registered as program scan memory.
8-2
Advertisement
Table of Contents
