Table of Contents
Advertisement
Sorting the Callsign
You can sort the Callsign list.
1 Press [MODE] in the Callsign list selection screen.
The move position selection screen appears.
2 Select a move position and press [A/B].
When you move an item to the end of the list, select [Move
to End] and press [A/B].
DIRECT REPLY
This function allows you to reply to a received call by simply
pressing [PTT] while displaying the interrupt screen in DV
and DR mode. The default setting is
signal is received in a DR mode and you immediately reply
to a CQ or a call to your Callsign, the transmission setting
is temporarily changed automatically and you can reply by
simply pressing [PTT].
The <
> icon appears in the interrupt screen when a direct
reply is possible in receiving a call. If [PTT] is pressed when
this icon appears, the setting is automatically changed to the
reply setting and transmission becomes possible.
Entire interrupt screen
Half interrupt screen
Note:
¡ The change of the transmission setting are temporary. After
display hold time elapses, it returns to the previous transmission
setting.
¡ When receiving the repeater frequency in DV mode, you can not
reply to a received call by pressing
Setting Direct Reply to Off
1 Access Menu No. 612.
2 Select [Off].
Note:
¡ You can change the display hold time by Menu No. 643.
¡ Direct reply is not possible when display method (Menu No. 640)
is set to [Off].
¡ When the direct reply is set to [On], the interrupt screen of DV
and DR mode is displayed in priority than APRS mode.
On
. When a repeater
[
]
[PTT]
.
AUTO REPLY FUNCTION
This function is to set automatically the Callsign of the other
station and reply when a signal to your Callsign is received.
1 Select [Auto Reply] in the Digital Function Menu.
2 Select [Off], [On], or [On(Voice)].
•
When [On] or [On(Voice)] is set, the <
appears on the display.
[On]: Transmission is possible with either the transmission
message or GPS location information depending on the
setting. Voice is not transmitted
[On(Voice)]: An auto reply voice message recorded in
the voice message memory in advance can be selected
and transmitted. Transmission is possible with either
the transmission message or GPS location information
depending on the setting.
Selecting the Auto Reply Voice Message
You can select an auto reply voice message from the voice
message memory.
1 Access Menu No. 312.
2 Select the voice file and press [A/B].
Note:
¡ Only one file can be selected.
Auto Reply Timing
You can set the Auto Reply timing.
1 Access Menu No. 613.
2 Select [Immediate], [5], [10], [20], [30], or [60] seconds.
RX HISTORY
Up to 100 entries containing information such as the Callsigns
of the station that transmitted the signal and the repeater
used can be stored in RX history for signals received in DV/
DR mode. The RX history is not cleared when the power is
switched OFF.
16-5
> icon
Advertisement
Table of Contents
