Table of Contents
Advertisement
PROGRAMMABLE VFO
If you always check frequencies within a certain range,
you can set upper and lower limits for frequencies that are
selectable. For example, if you select 144 MHz for the lower
limit and 145 MHz for the upper limit, the tunable range will be
from 144.000 MHz to 145.995 MHz.
1 Select the Band A.
2 Select your desired VFO frequency.
3 Access Menu No. 100.
The lower frequency limit blinks.
4 Select with [
]/[ ] or [ENC] control your desired lower
frequency limit, and press [ENT].
The upper frequency limit blinks.
5 Select with [
]/[ ] or [ENC] control your desired upper
frequency limit.
6 Press [A/B] to set the selected value.
Note:
¡ You cannot program the 100 kHz and subsequent digits. The
exact 100 kHz and subsequent digits of the upper limit depend
on the frequency step size you are using.
¡ The upper limit frequency cannot be set lower than the selected
lower limit frequency.
BEAT SHIFT
Since the transceiver uses a microprocessor to control various
transceiver functions, the CPU clock oscillator's harmonics
or image may appear on some spots of the reception
frequencies. Select a Beat Shift setting from Type 1 ~ Type 8,
which does not cause interference.
1 Access Menu No. 101
2 Select among from [Type 1] to [Type 8].
AF/ IF/ DETECT OUTPUT MODE
Selecting [AF], [IF], or [Detect] also outputs IF and detection
signals from the speakers.
Connecting diagrams with the PC
PC
1 Press [A/B] to select a band B.
2 Press [F], [A/B] to select the Single band.
3 Access Menu No. 102.
4 Select [AF], [IF], or [Detect].
AF output mode [AF]:
The received sound is output.
IF output mode [IF]:
The received IF signal of the band B is output to the PC.
•
Change the frequency with [
•
Change the band with
Detect output mode [Detect]
The decoded signal of the band B is output to the PC.
•
Change the frequency with [
•
Change the band with
•
Change the modulation/demodulation mode with [MODE].
Note:
¡ When other than [Off(AF)] is selected, the A band is hidden and
the received audio output of the A band stops.
¡ When KISS mode is on, [IF] or [Detect] cannot be selected in
the menu.
¡ If the B band is not the operation target, [IF] or [Detect] cannot
be selected in the menu.
¡ When DV mode is selected, [Detect] cannot be selected in the
menu.
¡ For IF12kHz output, you can select the modulation/demodulation
mode from AM/LSB/USB/CW.
12-2
USB Connector
(USB Type-C
)
TM
USB Cable
]/[ ] or [ENC] control.
[ ]
/[
].
]/[ ] or [ENC] control.
[ ]
/[
].
Advertisement
Table of Contents
