16 OTHER FUNCTIONS
Starting Sky Command System II Operation
After you have completed setting up the following, you can start
Sky Command System II operation. Without programming these
parameters, you cannot use Sky Command System II.
TS-890S + TH-D7A/ TH-D72(A/E)/ TM-D700A/ TM-
D710/G(A/E)/ TM-V71A + RC-D710 (Transporter)
Setup
1 Configure the TH-D7A, TH-D72(A/E)/ TM-D710/G(A/
E), TM-V71A + RC-D710, or TM-D700A as a
"Transporter" and connect all the necessary cables
to the TS-890S transceiver.
2 Select a frequency on the TS-890S transceiver.
3 On the TS-890S, press [MENU], then access Menu
[7-00] (Baud Rate (COM Port)).
4 Select the desired communication speed.
5 Select the same communication parameters to
match the TH-D7A, TH-D72(A/E)/ TM-D710/G(A/E),
TM-V71A + RC-D710, or TM-D700A transceiver.
6 Press [MENU] to exit Menu mode.
7 Configure and start the Transporter mode on the
TH-D7A, TH-D72(A/E)/ TM-D710/G(A/E), TM-V71A +
RC-D710, or TM-D700A transceiver.
• Refer to the respective instruction manuals of the TH-D7A,
TH-D72(A/E)/ TM-D710/G(A/E), TM-V71A + RC-D710, or
TM-D700A for information on how to connect, configure,
and operate the transceivers for Sky Command System II.
16-18