7-Inch Ir Speed Dome Settings - HIKVISION DS-2AE7232TI-A Quick Start Manual

1.2.3 7-inch IR Speed Dome Settings

Two DIP switches SW1 and SW2 are for setting the speed dome address, baudrate, protocol, etc.,
with value ON=1 and OFF=0. The switch label is on the back of the SWITCH cover as shown in Figure
1-8.
Each number of the switch represents a DIP value, ranging from 1 to 8 for the lowest to highest.
SW1
The default dome address is 0; the default baudrate is 2400; and the default value of the 120Ω
terminator is OFF.
 Address Settings
The SW1 switches are used for setting the address of speed dome. You can refer to Table 1-12 for
details of setting the speed dome address to a specific number.
Dome Address
0
1
2
3
...
255
HD-TVI Speed Dome·Quick Start Guide
Figure 1-8 Label of DIP Switch for IR Speed Dome
ON
1 2 3 4 5 6 7
Figure 1-9 Enlarged View of DIP Switch
Table 1-12 Set the Dome Address
1 2
OFF OFF OFF
ON OFF OFF
OFF ON OFF
ON ON OFF
... ...
ON ON ON
7
SW1
ON
SW2
8 1 2 3
3 4 5
OFF OFF
OFF OFF
OFF OFF
OFF OFF
... ... ...
ON ON
SW2
4 5 6 7 8
6 7 8
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
... ... ...
ON ON ON