Table of Contents
Advertisement
Table continued from last page
4.
The function (addition of steam during cooking) can also be switched off during cooking.
Touch
. Symbol
NOTE: If the steam injection is not set before starting operation, this can be set during cooking.
Filling the water tank
The water tank allows for independent feeding of water into the oven. The volume of the tank is
approximately 1.3 dl.
Always fill the tank with clean water from the water supply network or bottled water without additional
admixture. The water poured into the tank must have a room temperature of approximately 20 °C (+/
10 °C).
INFORMATION!
The water tank cannot be removed from the appliance.
1.
Remove the water tank from the housing by pressing the knob. When you press the knob, the
tank jumps out.
2.
Pour the water up to the MAX mark on the water tank.
3.
Press the water tank back into the housing as far as it will go (it will click into place).
NOTE: After the end of use, the remaining water is poured into the evaporator tray in the oven,
which is placed under the ceiling of the oven room and is suspended from the grill heater (infrared
heater). (For cleaning, see chapter 11.2 Cleaning the evaporator tray and 11.3 Cleaning the steam
system.)
WARNING!
If you do not observe the MAX indicator and pour too much water into the tank, excess
water might spill onto the ground through the gap between the tank cover and the tank.
Do not use distilled water, tap water with high chlorine content, or other similar liquids.
Use only fresh tap water, softened water or non-carbonated mineral water.
5.5 Automatic cooking mode
18
remains partially illuminated on the display.
Advertisement
Table of Contents
