Connect the Ethernet Cable
Insert one end of the Ethernet cable to the
"ENET" port on the back of the U.S. Robotics
SureConnect ADSL Ethernet Modem. Connect
the other end of the Ethernet cable to the
Ethernet port on your computer's 10/100
network interface card. The "ENET" LED on the
front of the modem will illuminate. Click Next.
To connect the U.S. Robotics SureConnect ADSL
Ethernet Modem directly to a computer or to the
uplink port of a hub or router, use the Ethernet
cable that was provided with your modem. The uplink port is used to attach any
additional hubs to the broadband router in order to expand the Local Area
Network (LAN)
SureConnect ADSL Ethernet Modem is a straight-through UTP copper cable. To
connect the modem to a port other than the uplink port of a hub, you must use
a crossover UTP cable.
8
.
The Ethernet cable that came with your U.S. Robotics
Connect the Telephone Cable
Connect one end of the included telephone
cable to the telephone port on the back of
your modem labeled "ADSL" and connect the
other end into the telephone jack on the wall.
The "ADSL" LED will illuminate. Click Next.
The modem will begin the initialization
process. This will take a few moments.