US Robotics USR9001 Quick Installation Manual page 14

Installing on a Macintosh Computer or
in a Linux Environment
If you are installing the U.S. Robotics SureConnect ADSL Ethernet
Modem on a Macintosh, in a Linux environment, or do not intend to
install the SureConnect utility you will only need to connect the modem
cables. Once the cables are connected, your ISP may require that you
install a PPPoE client.
Connect the Power Adapter
Be sure to only use the included power supply. Plug the power adapter cord into
the "10VDC" jack at the rear of the modem. Plug the power adapter into a
standard wall outlet. The modem is always supplied with power, so there is no
power switch to turn on. The "PWR" LED on the front panel of the modem will be
illuminated if power is being supplied to the modem.
Connect the Telephone Cable
Connect one end of the included telephone cable to the telephone port on the
back of your modem labeled "ADSL" and connect the other end into the
telephone jack on the wall. The "ADSL" LED should illuminate.
Connect the Ethernet Cable
Insert one end of the Ethernet cable to the "ENET" port on the back of the U.S.
Robotics SureConnect ADSL Ethernet Modem. Connect the other end of the
Ethernet cable to the Ethernet port on your computer. The "ENET" LED should
illuminate
If your ISP gave you software to install, you should do so at this time. You can
test your connection by registering your modem at:
10
In Windows 95, a Registration screen will not display. You can
register your modem by accessing the About page of the U.S.
Robotics SureConnect ADSL utility. If the Registration screen does
not display, go to the Troubleshooting section of this Quick
Installation Guide and review the Troubleshooting Checklist.
www.usr.com/support/warranty-reg.asp