Cleaning The Gas Hob - Atag FG9011EAN Manual

MAINTENANCE

Cleaning the gas hob

EN 22
Removing the runners
You can remove both runners to clean the oven easier. The runners are
attached to the oven wall at three points (see figure).
1. Click the runner out of the lock by pushing in the middle of the top
of the runner.
2. Lift the runner upwards slightly and pull it outwards.
To put the runners back in place, proceed in reverse order.
3. Place the lower part of the runner on the two lower attachment
points.
4. Then press and click the upper part back into the upper attachment
point.
Your gas hob has been manufactured from high-grade, easy to clean
materials.
• Regular cleaning immediately after use prevents food spills from
being able to become ingrained and cause stubborn stains that are
difficult to remove. Use a mild cleaning agent. Do not use too much
moisture, as there is a risk that it will penetrate into the burner or
vent holes.
• Clean the control knobs, burners, and pan supports first and then
the drip tray. This avoids the drip tray getting dirty again during
cleaning.
• The ignition plugs should preferably be cleaned with a cloth. Do
this carefully. Otherwise the spark plug can become defective. The
spark plug will only operate correctly in a dry environment. If the
plug is very dirty, you can clean it with a tiny brush.
• Set the pan supports down vertically, without sliding them over the
drip tray.
• Assemble the burner parts using the guide ridges. Pay attention to
the notches for the ignition plug and thermocouple. Make sure the
burner parts are lying flat.