Faults; Faults Table - Atag FG9011EAN Manual

FAULTS

Faults table

Problem with the hob
There is a smell of gas in the
vicinity of the appliance.
A burner won't ignite.
EN 24
When in doubt about the proper operation of your appliance, this does
not automatically mean there is a defect. Make sure to check the points
mentioned below in the table first, or visit our website 'www.atag.nl'
for more information.
Possible cause
The gas connection of the
unit is leaking.
Plug not in socket.
Fuse defective / fuse in
meter cabinet switched off.
Spark plug dirty/damp.
Burner parts not correctly
installed.
Burner parts dirty /
damp.
Main gas tap is off.
Fault in the gas network.
Gas bottle or gas tank is
empty.
Wrong type of gas used.
Control knob not pressed in
deep enough.
Solution
Turn off the main gas tap.
Contact your
installer.
Plug the plug into the
wall socket.
Fit a new fuse or switch the
automatic fuse back on.
Clean/dry the spark plug.
Assemble the burner parts
using the centring ridges.
Clean/dry the burner
components. Make sure that
the outflow holes are open.
Turn on the main gas tap.
Check with your gas supplier.
Connect a new gas bottle or
have the tank filled.
Check that the gas used is
suitable for the appliance. If
not, contact your gas fitter.
Keep the control knob
pressed in far enough
between full and low. At first
use this can take some more
time because of the gas
supply.