Bundling Cables; Precautions; Bundling Steps; Checklist After Installation - Ruijie RG-MAP852V3 Hardware Installation And Reference Manual

Hardware Installation and Reference Guide
3.6

Bundling Cables

3.6.1

Precautions

Bundle the power cords and other cables in a visually pleasing way.

Bend twisted pairs naturally or to a large radius close to the connector.

Do not over tighten twisted pair bundle as it may reduce the cable life and

performance.
3.6.2

Bundling Steps

Bundle the hanging part of the twisted pairs using cable ties and lead them to the

LAN/PoE port end of the AP by convenience.
Fasten the twisted pair cables to the cable trough of the mounting bracket.

Extend the twisted pair cables under the device and route them in a straight line.

3.7

Checklist After Installation

3.7.1

Checking the AP

Cut off the power switch before installing or moving the AP.

Ensure that screws are securely fastened.

Ensure that the AP is installed at a site where the LED can be easily observed.

3.7.2

Checking Cable Connection

Make sure that the twisted pair cable matches the port type.

Verify that cables are properly bundled.

3.7.3

Checking the Power Supply

Verify that the power cord is properly connected and compliant with safety

requirements.
Verify that the access point is operational after power-on.

22
Installing the Access Point