US Robotics USR5462 User Manual page 64

Troubleshooting
3. Then type ipconfig/renew.
D. The 10/100 LED does not light after a connection is made.
1. Check that the host computer and the 802.11g 54Mbps Router
are both powered on.
2. Be sure the network cable is connected to both devices.
3. Verify that Category 5 cable is used if you are operating at
100 Mbps, and that the length of any cable does not exceed
100 m (328 ft).
4. Check the network card connections.
5. The 10BASE-T/100BASE-TX port, network card, or cable may be
defective.
E. If wireless clients cannot access the network, check the
following:
1.Be sure the 802.11g 54Mbps Router and the wireless clients
are configured with the same Service Set ID (SSID).
2. If authentication or encryption are enabled, ensure that the
wireless clients are properly configured with the appropriate
authentication or encryption keys.
60