US Robotics USR5462 User Manual page 11

Launch a Web browser. In the location or address line of your Web
1.
browser, type
http://192.168.2.1 to access the Web User Interface.
After the connection is established, you will see the Web User Interface.
The default password is admin. Click Login.
When you access the Web User Interface, click the Setup Wizard.
Note: If you are prompted to connect to the Internet, you may need to select
Try Again or Connect, depending on your Internet browser.
2. Select your Time Zone and then click Next.
3. Choose your Broadband Type. (Enter the appropriate information for
the type of Internet connection you chose.) When you are finished, click
Next. Refer to "Broadband Type" on page 12 for more information.
4. If required, enter the IP address Info for the 802.11g 54Mbps Router and
then click Finish.
After finishing the Setup Wizard, if it does not report "Connected," perform
the steps of the Setup Wizard again.
If Web User Interface still did not report "Connected," or if at anytime you
want to validate your Internet settings, click Advanced Setup and select
Status.
To make a wireless connection:
Make sure each wireless adapter that will be connected to the network is
set to Infrastructure mode. If you purchased the USR5470 Wireless Starter
Kit, refer to the Navigating the Wireless Configuration Utility section of the
802.11g 54Mbps USB Adapter User Guide on the Installation CD-ROM to
determine how to change this setting and for instructions on collecting
your configuration information. If you are connecting a different wireless
adapter, refer to that wireless adapter's documentation.
Installing the 802.11g 54Mbps Router
7