Events - GEM eSyStep 543 Operating Instructions Manual

12.4.31 Operating times
The current valve travel times can be read out with the Operating times parameter.
Index Sub- Off- Access
In- set Rights
dex
0x62 1 0 RO
2 8 RO
Description of parameter values
Index name
Operating times
12.4.32 Drive sets
The traverse speed and force of the actuator can be influenced with the Drive sets parameter when the valve is initialized.
Index Sub- Off- Access
In- set Rights
dex
0x90 1 0 R/W
2 8 R/W
Description of parameter values
Index name
Drive sets
Speed
Actuator size
AG0 and AG1
Force settings
Actuator size
AG0 and AG1

12.5 Events

The following IO-Link events can be transmitted.
Event
Device Hardware Fault
Motor Unable To Move
Device Temperature Over-Run
Emergency Power
Primary Supply Voltage Under-Run
www.gemu-group.com
Length Index name
8 bits Operating times
8 bits
Parameter Values
Open 0 to 255
0 to 25.5 s
Close 0 to 255
0 to 25.5 s
Length Index name
2 bits Drive sets
3 bits
Parameter Values
Speed 1 ... 3
Force 1 ... 6
Setting parameter
Setting parameter
Parameter Type
Open uint:8
Close uint:8
Read out operating time (in tenths of seconds) from end pos-
ition CLOSED to end position OPEN.
Read out operating time (in tenths of seconds) from end pos-
ition OPEN to end position CLOSED.
Parameter Type
Speed
Force
Select the speeds for the average travel range.
Set the force for the average travel range and for sealing.
Preset at the factory depending on the valve type.
1 (43 %)
2 (71 %)
3 (100 %)
1
6
Mode
App/Disapp Error
App/Disapp Error
App/Disapp Warning/Error
App/Disapp Warning
App/Disapp Error
59 / 68
12 Specific data IO-Link (pin 6)
Default Values
0 0 to 255,
0 to 25.5 s
0 0 to 255,
0 to 25.5 s
Description
Default Values
3 1 ... 3
- 1 ... 6
Description
Average speed in mm / s
1.6
2.3
3.0
Force
Minimum force
Maximum force
Type Code
0x5000
0x8CE0
0x4210
0x5100
0x5111
GEMÜ 543 eSyStep
OPEN / CLOSE (Code AE)