Zip HydroTap G5 Installation Instructions Manual
Hide thumbs
Also See for HydroTap G5:
- Quick start manual ,
- Quick start installation manual (48 pages) ,
- Installation instructions manual (44 pages)
Related Manuals for Zip HydroTap G5
Summary of Contents for Zip HydroTap G5
- Page 1 Installation instructions HydroTap G5 Faucets - Arc & Cube English French Visit our website to download the manuals Quick Start Installation Guide 807112US v1.01 01.22 G5 HydroTap Arc Cube instructions...
- Page 2 Table of contents SECTION 1: Using these instructions ..............2 1.1 Using these instructions ................2 SECTION 2: Performance data & regulatory standards ........3 SECTION 3: Generic installation requirements ..........4 3.1 Tools needed for faucet installation ............4 SECTION 4: Installation - Arc & Cube ............... 4 4.1 Positioning ....................
- Page 3 SECTION 2: Performance data & regulatory standards • The ARC XX and Cube XX faucets have been certified by IAPMO R&T against NSF/ANSI Standard 42, NSF/ANSI Standard 53, NSF/ANSI Standard 372, CSA B483.1, ASSE 1087, and ASSE 1023 when used as part of the BCS60, BCS20, BCS Home, BC40, and BC Home systems.
- Page 4 SECTION 3: Generic installation requirements 3.1 Tools needed for faucet installation In addition to normal tools, the following (or equivalent equipment) will be required not supplied). • 1 3/8”, (35mm) diameter sheet metal hole punch for sinks. • 1 3/8”, (35mm) diameter hole saw for worktops. •...
- Page 5 SECTION 4: Installation - Arc & Cube 4.2 Select height & spout position see 4.1 2 fixed height options 6 fixed position options 4.3 Set up the height and spout position • Remove spout locating screws, lower spout to expose the spring clip. •...
- Page 6 SECTION 4: Installation - Arc & Cube 4.4 Cut the hole • Cut a 1 3/8”, (35mm) hole in the worktop / sink. • Make sure the faucet location will allow the spout to drain into the sink. 1 3/8”, (35mm) 4.5 Mount the faucet Upper o-ring Base...
- Page 7 SECTION 4: Installation - Arc & Cube 4.7 Secure the tube kit & fit the label Align herbie clip with vent connector Function label Clamp tight surface with herbie clip 4.8 Command Centre connections Connected to the faucet. Boiling out Red silicone tube from faucet.
- Page 8 Images in this booklet have been modified and may not be true representations of the finished goods. The terms “Zip” and “HydroTap” are registered trade marks of Zip Water (Aust) Pty Ltd. The ARC XX and CUBE XX faucets have been certified by IAPMO R&T against NSF/ANSI Standard 42, NSF/ANSI Standard 53, NSF/ANSI Stand- ard 372, CSA B483.1, ASSE 1087, and ASSE 1023 when used as part of the...
Need help?
Do you have a question about the HydroTap G5 and is the answer not in the manual?
Questions and answers