Installing The Fan Tray - Siemens SIMATIC NET RUGGEDCOM MX5000RE Equipment Manual

Installing the Device
2.10 Installing the Fan Tray
2.
3.
4.
5.
6.
7.
8.
9.
10. Apply Loctite® 242 to four SS304 truss head philips drive screws.
11. Secure both patch panels to the RUGGEDCOM MX5000RE with four SS304 truss
2.10

Installing the Fan Tray

To intall the fan tray, do the following:
1.
28
WARNING
Crushing hazard – risk of serious injury or damage to equipment
Make sure the device is properly supported at all times. It is highly
recommended to employee the assistance of another technician.
Have an assistant hold the attached cables and patch panel clear of the
RUGGEDCOM MX5000RE sides.
Hold the RUGGEDCOM MX5000 by both mount bracket handles and lower it into
the RUGGEDCOM MX5000RE.
Lower the RUGGEDCOM MX5000 unit until the mount bracket flanges are
supporting the unit on the inner mount bracket surfaces. If the RUGGEDCOM
MX5000 does not lower far enough, make sure the support pins on the back
of the mount brackets are properly aligned with the alignment holes inside the
RUGGEDCOM MX5000RE.
Secure the RUGGEDCOM MX5000 to the RUGGEDCOM MX5000RE using 18
screws, flat washers and split lockwashers. Make sure each screw is assembled
with two flat washers, one split lockwasher and then the screw.
Place one exterior tooth lockwasher on the inside grounding stud found on the
right side of the RUGGEDCOM MX5000RE.
Attach the free end of the grounding cable to the inside grounding stud using
two hex nuts.
Carefully pass the PS1 power supply cable assembly through opening E on the
bottom of the RUGGEDCOM MX5000RE.
Carefully pass the PS2 power supply cable assembly through opening G on the
bottom of the RUGGEDCOM MX5000RE.
Note
When aligning the patch panels, the inside grounding stud should be toward the
back of the RUGGEDCOM MX5000RE.
head philips drive screws.
Position the fan tray the DB25 connectors facing forward when the fan tray is in
the RUGGEDCOM MX5000RE.
RUGGEDCOM MX5000RE
Equipment Manual, 11/2023, C79000-G8976-1060-17