Siemens SIMATIC NET RUGGEDCOM MX5000RE Equipment Manual page 53

Communication ports
3.1 Media modules
5.
6.
7.
Installing a media module
To install a media module, do the following:
1.
2.
3.
4.
44
1
2
3
Figure 3.2 Removing a media module
Install a new media module or a blank module (to prevent the ingress of dust
and dirt).
[Optional] If necessary, install the device in the rack.
For control and switch modules only, connect power to the device.
For control (CM) and switch (SM) modules only, make sure power to the device
has been disconnected and wait approximately two minutes for any remaining
energy to dissipate.
[Optional] If the device is installed in a rack, remove it from the rack.
Remove the current media module from the slot.
Insert the new media module into the slot.
1
2
3
Figure 3.3 Installing a media module
RUGGEDCOM MX5000RE
Equipment Manual, 11/2023, C79000-G8976-1060-17